Roll Forming

Roll Forming IntroductionModel Roll Forming Machine consists of uncoiler and its base, coil sheet guiding equipment, film covered device, roll forming system, post-cutting equipment, hydraulic station, controlling system, supporter table.Technical ParametersMaterial SpecColored steel sheet / galvanized steel sheetThickness of Coil Sheet0.3 --0.7 mmMain Motor Power7.5kwForming Speed8--10m/minHydraulic Station Power3kwQuantity of StandsAbout 18 groupsHydraulic Pressure10 12MpaControlling SystemPLCIndex Error of Length10m±2mmTotal WeightAbout 1000kgVoltage380V 3 phase 60Hz or to the buyer's requirementMaterial of Main EquipmentRoller Materialhigh grade No.45 forged steel, plated hard chrome on the surface of roller with thickness 0.05mmActive Shaft Materialhigh grade No.45 carbon wrought steel at Φ 75mm.Cutter BladeCr12 mould steel with quenched treatment.Electric ElementsControl system with PLC model S7-200, Siemins.transducer with ABB control panel with TP170, Siemens. It can input 10sets of spec at one timeOil Tank ModelCB-E310Component and Function1. Sheet guiding equipment: Using guiding equipment of leader sliding block style. The width and the left or right position can be adjusted only by adjusting the leader, then the sliding block can realize left or right movement.2. Mainframe Transmission: Transfer the main motor power to the rollers through chains and sprockets, and also transfer the coil sheet.3. Roll forming system: The main frame of machine is welded separately and the outside wall is connected by screw after being roto-blasted on the surface. The rollers are surface-chrome plated after being machined by the exact machine tool..Designated use1. Some final products for Automobile.2. Some final products for Building, such as for Roofing / Ceiling / Wall materials, and dry wall (track and stud) material.3. Some final products for Gate-Panel, Guard-Panel and sound insulation